SHERWIN-WILLIAMS CO -- VARNISHES, FAST DRY VARNISH W54 V 707 GLOSS -- 8010-00N043162 
=====================  Product Identification  =====================

Product ID:VARNISHES, FAST DRY VARNISH W54 V 707 GLOSS
MSDS Date:08/12/1988
FSC:8010
NIIN:00N043162
=== Responsible Party ===
Company Name:SHERWIN-WILLIAMS CO
Address:101 PROSPECT AVE
City:CLEVELAND
State:OH
ZIP:44101
Country:US
Info Phone Num:216-566-2902
Emergency Phone Num:216-566-2917
CAGE:54636
=== Contractor Identification ===
Company Name:SHERWIN-WILLIAMS CO THE
Address:101 PROSPECT AVE NW
Box:City:CLEVELAND
State:OH
ZIP:44115-1042
Country:US
Phone:800-251-2486/216-566-2242
CAGE:54636

=============  Composition/Information on Ingredients  =============

Ingred Name:KEROSENE (PETROLEUM), HYDROTREATED; (MINERAL SPIRITS). VP:2
CAS:64742-47-8
RTECS #:OA5504000
Fraction by Wt: 30-60%
OSHA PEL:5 MG/M3 OIL MIST
ACGIH TLV:5 MG/M3 OIL MIST

Ingred Name:MINERAL SPIRITS. VP:0.5
CAS:64742-88-7
Fraction by Wt: 0-20%
OSHA PEL:5 MG/M3 OIL MIST
ACGIH TLV:5 MG/M3 OIL MIST

Ingred Name:SUPP DATA:BE HARMFUL/FATAL. COATING MAY CONTAIN MATL
    CLASSIFIED AS NUISANCE PARTICULATES, SUCH AS TITANIUM (ING 4)
RTECS #:9999999ZZ

Ingred Name:ING 3:DIOXIDE OR CALCIUM CARBONATE (SEE ACGIH TLV LIST,
    PREFACE & APPENDIX D OF ORIG MSDS, CONT NEHC ), (ING 5)
RTECS #:9999999ZZ

Ingred Name:ING 4:WHICH MAY BE PRESENT AT HAZ LEVELS ONLY DURING
    SANDING/ABRADING OF DRIED FILM. IF NO SPECIFIC DUSTS ARE (ING 6)
RTECS #:9999999ZZ

Ingred Name:ING 5:LISTED IN INGRED SECT, APPLIC LIMITS FOR NUISANCE
    DUSTS ARE TLV 10 MG/M3 (TDUST), PEL 15 MG/M3 (TDUST), (ING 7)
RTECS #:9999999ZZ

Ingred Name:ING 6:5 MG/M3 (RESPIRABLE FRACTION).
RTECS #:9999999ZZ

Ingred Name:RESP PROT:APPROVED DUST/MIST RESP FOR DUST WHICH MAY BE
    GENERATE FROM PROD, UNDERLYING PAINT OR THE ABRASIVE.
RTECS #:9999999ZZ

Ingred Name:VENT:LIMITS. REFER TO OSHA STANDARDS 1910.94, 1910.107,
    1910.108.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: IRRITATION OF EYES, SKIN &
    RESPIRATORY SYSTEM. MAY CAUSE NERVOUS SYSTEM DEPRESSION. EXTREME
    OVEREXPOSURE MAY RESULT IN UNCONSCIOUNESS & POSSIBLY DEATH.
    HEADACHE, DIZZINESS, NAUSEA & LOSS OF COO RDINATION ARE INDICATIONS
    OF EXCESSIVE EXPOSURE TO VAPORS OR SPRAY MISTS. REDNESS & ITCHING
    OR BURNING (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:SENSATION MAY INDICATE EYE OR
    EXCESSIVE SKIN EXPOSURE. CHRONIC: PROLONGED OVEREXPOSURE TO SOLVENT
    INGREDIENTS LISTED IN INGREDIENT SECTION MAY CAUSE ADVERSE EFFECTS
    TO THE LIVER & URINARY SYS TEMS. REPORTS HAVE ASSOCIATED REPEATED &
    PROLONGED OVEREXPOSURE TO SOLVENTS W/PERM BRAIN & NERVOUS SYSTEM
    DAMAGE.
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.

=======================  First Aid Measures  =======================

First Aid:INHAL:IF AFFECTED, REMOVE FROM EXPOSURE. RESTORE BREATHING.
    KEEP WARM & QUIET. SKIN:WASH AFFECTED AREA THOROUGHLY W/ SOAP &
    WATER. REMOVE CONTAMINATED CLOTHING & LAUNDER BEFORE REUSE. EYES:
    FLUSH W/LA RGE AMOUNTS OF WATER FOR AT LEAST 15 MINS. GET MEDICAL
    ATTENTION. INGEST:CALL MD IMMEDIATELY .

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:>102F,>39C
Lower Limits:0.9%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL OR FOAM.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
    . WATER SPRAY MAY BE INEFT. IF WATER IS USED, FOG NOZZ ARE PREF.
    WATER MAY BE USED TO COOL CLSD (SUP DAT)
Unusual Fire/Explosion Hazard:KEEP CONTRS TIGHTLY CLSD. ISOLATE FROM
    HEAT, ELEC EQUIP, SPARKS & OPEN FLAME. CLSD CONTRS MAY EXPLODE WHEN
    EXPOSED TO EXTREME HEAT. APPICATN TO HOT (SUPP DATA)

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE &
    REMOVE W/INERT ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:CONTENTS ARE COMBUST. KEEP AWAY FROM
    HEAT & OPEN FLAME. KEEP CONTR CLSD WHEN NOT IN USE. USE ONLY W/ADEQ
    VENT. AVOID BRTHG VAP/SPRAY MIST.
Other Precautions:AVOID CONT W/SKIN & EYES. CONSULT NFPA CODE. USE
    APPRVD BONDING & GROUNDING PROCEDURES. TRANSFER ONLY TO APPRVD
    CONTRS W/COMPLETE & APPROP LABELING. DO NOT TAKE INTERNALLY. KEEP
    OUT OF REACH OF CHILDR EN. INTENTIONAL MISUSE BY (SUPP DATA)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF PERSONAL EXPOS CANNOT BE CONTROLLED BELOW
    APPIC LIMITS BY VENT, WEAR A PROPERLY FITTED NIOSH/MSHA APPRVD ORG
    VAP/ PARTICULATE RESP FOR PROT AGAINST MATLS IN INGRED SECTION.
    WHEN SANDING/ ABRADING D RIED FILM, WEAR A NIOSH/MSHA (ING 8)
Ventilation:LOC EXHST PREF. GEN EXHST ACCEPTABLE IF EXPOS TO MATLS IN
    INGRED SECTION IS MAINTAINED BELOW APPLIC EXPOS (ING 9)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL SAFETY GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:WASH HANDS AFTER USING.
Supplemental Safety and Health
FIRE FIGHT PROC:CONTRS TO PVNT PRESS BUILD- UP & POSS AUTOIGNTION OR
    EXPLOS WHEN EXPOSED TO EXTREME HEAT. EXPLO HAZ: SURF REQS SPEC
    PRECS. DURING EMER CNDTNS, OVEREXPOS TO DECOMP PRODS MAY CAUSE A
    HLT H HAZ. SYMPS MAY NOT BE IMMED APPARENT.OBTAIN MED ATTN. OTHER
    PREC:DELIB CONCENTRATING & INHALING CONTENTS CAN (ING 3)

==================  Physical/Chemical Properties  ==================

HCC:F4
Boiling Pt:B.P. Text:>300F,>149C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:0.86-0.89
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:56-71

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:BY FIRE:CARBON DIOXIDE & CARBON
    MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASTE FROM PROD MAY BE HAZ AS DEFINED UNDER THE
    RCRA 40 CFR 261. WASTE MUST BE TESTED FOR IGNITABLITY TO DETERM
    APPLIC EPA HAZ WASTE NOS. INCIN IN APPRVD FACILITY. DO NOT INCIN
    CLSD CONTR. DISP OF I/A /W FED, STATE & LOC REGS REGARDING
    POLLUTION.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.